Gear motors made with aluminium alloy body and cast iron flanges and rear covers.

More details

  • Gear motors made with aluminium alloy body, cast iron flanges and covers.

  • Displacements from 0.27 to 1.58 cu.in/rev.

  • High volumetric efficiency achieved by floating bushings and axial compensation.

  • Integral gear with 12 teeth.

  • Double shaft seal.

  • Available with flanges, shafts and ports for the main European, German and American standards.

  • Available supports with bearing.

  • Wide range of rear covers with built-in valves.

Air compressor drive release:

  • electric or manual motor speed control;

  • electric venting valve.

Fan drive release:

  • proportional electric valve to control the speed of the motor;
  • 4/2 ON-OFF electric valve to reverse the rotation.

Reversible release:

  • available also with internal drain.

Specifiche tecniche

Displacements cmc/rev-cu.in.rev 4.60 - 0.27
Max starting pressure P2 bar - psi 280 - 4060
Min rotation speed min-1 600
Max rotation speed min-1 4000
Max continuous pressure P1 bar-psi 250 - 3625


Need more informations about this product
Models list